Description
Cel-Fi GO Cellmate V2 – Portable Mobile Repeater IP67 Telstra Cel-Fi GO Cellmate V2 – Portable Mobile Repeater IP67 Telstra
TELSTRA GO 3G (850) OR 4G (700/1800) – SINGLE BAND
Introducing the Cel-Fi Cellmate, a portable mobile repeater in an industrial case that can be transported and used where mobile signal is needed.
The Cel-Fi Cellmate for Telstra Smart Repeater is the ideal product to boost and distribute a 3G/4G mobile signal within your car, 4WD, or truck and for emergency services, being transported between fleet vehicles, construction or mining sites. Supporting voice and mobile internet for multiple mobile devices, dropped calls and slow internet are a thing of the past. Cellmate features a Cel-Fi GO, power supply and battery backup in a Pelican Case 1400 which is IP67 Watertight, crushproof and dustproof. Coupled with antennas (sold separately) and the Cel-Fi WAVE smartphone app, Cellmate is the ideal solution to resolve coverage challenges, in the harshest environments
Ideal for emergency services, being transported between fleet vehicles, construction or mining sites. The Cellmate includes a Cel-Fi Mobile repeater that can boost a 3G or 4G mobile signal on the Telstra, Optus and Vodafone network.
- Cel-Fi Cellmate for repeating Telstra GO 3G (850) or 4G (700/1800)
- Select manual or auto, to boost 3G or 4G (only one band at a time)
- Pelican Case 1400 – IP67 Watertight, crushproof, and dustproof – 340x295x152mm
- 240 Mains Power Supply & 12V Vehicle accessory Lighter power supply inbuilt charger
- Truly portable solution with inbuilt battery – supplies power for up to 10 hours
- Bluetooth Cel-Fi WAVE App control. Reception level, boost level, 3G or 4G mode.
- Internal transmit antenna in the base of the case 5dBi thin panel type antenna
- External SMA/F Antenna port for connection to a high gain reception antenna
- External antenna, mount and cabling are sold separately
Powering Cellmate
The system can be powered from:
• Mains Power – using the included 240v Battery LED’s adaptor
• DC Power – using the included 12v cigarette plug adaptor
• Internal Battery – providing power for 6 to 10 hours
Charging the Internal Battery
• Connect a 12V cigarette adaptor or 240V mains power supply to the ‘power port’ on the Cellmate, and charging will start.
Connect External Antenna
• To receive a mobile signal an external antenna that supports your carrier’s specific cellular bands must be connected to the antenna port.
• The external antenna, mount, and cable are not included with the Cellmate.
• We offer a range of Blackhawk antennas that have been tested with Cellmate.
Optimising the Antennas
Cellmate includes an embedded ‘service antenna’ built into the base of the case.
The lid of the case features an RF shield to assist with isolation.
Antenna Isolation is Important: For Cellmate to work at optimal boost you need to separate/isolate the inbuilt ‘service antenna’ from the external antenna as much as possible. If the external antenna picks the signal that is disbursed from the inbuilt coverage antenna, then the boost and signal coverage area will be reduced.
Download Cel-Fi WAVE App
Cel-Fi WAVE is an App on your smart phone that enables you optimise the antenna setup:
• Check the input signal level from the network
• Check the ‘Boost’ figure (6-9 is ideal)
• Change mode or use the Mode Switch on the Cel-Fi GO
• 3G -will boost a 3G signal, • 4G/4GX -will boost a 4G signal
•Auto -will boost the strongest 3G or 4G signal
