cel-fi Telstra booster kit

$ 1,138.00 including GST

CEL-FI GO TELSTRA BOOSTER KIT

NameRangeDiscount
standard4 - 105 %

Description

 

 

Cel-Fi GO Repeater has been tested, authorized, and approved by Telstra for use on the Telstra Mobile Network
 

The Cel-Fi GO for Telstra Smart Repeater is the ideal product to boost and distribute a 3G/4G mobile signal in a caravan or home. Supporting voice and mobile internet for multiple mobile devices, boosting your mobile coverage whilst on holiday has never been easier.

Extends Mobile Phone battery life mobile phones use a lot more energy when in poor signal areas. The phone adjusts its internal power to compensate in an attempt to boost the poor signal. As a  result, the phone will consume a lot more battery power. Using the Cel-Fi system your indoor mobile signal should be high and the battery will last noticeably longer for you to talk. check Facebook and browse the internet.

Eliminate Dropped or Missed CallsNever miss or lose an important call because of coverage issues again. The  Cel-Fi will provide continuous coverage throughout your home or office, so you can be contacted when required. No longer do you have to put up with calls dropping out or terminating during the conversation.

PACK INCLUDES:– Cel-Fi GO Stationary Model– ‘Blackhawk LPDA Yagi 10m LMR240 cable– Indoor dome Antenna with 6m RG58 cable – 240v Mains Power Supply  (optional 12v cigarette plug)

FEATURES-100dB of system gain-Includes external and internal antennas– Locked to Telstra’s Mobile Network– Carrier approved– Band Selection Button 

 

Blackhawk LPDA YAGI Specifications

    • 11 dBi gain across lower bands 698-960  MHz
    • 12 dBi gain across upper bands 1710-2700  MHz
    • Ruggedised construction for Australian  conditions
    • Fully welded, powder coat aluminum design
    • Stainless steel mounting clamp included
    • 30 cm tail with pre-terminated N Female  connector
    • Supplied with 10 m of flexible PT240  LSHF cable
    • Ideal for high-speed 3G and 4G LTE  applications.
 

Ideal for Telstra Next-G and 4GX networks, .

 

Operating on all 3G and 4G frequencies in Australia and abroad, this high-grade antenna can be used in a range of residential, commercial, and industrial mobile broadband applications on any mobile network. This is the ideal external antenna for Cel-Fi repeater systems. The Blackhawk Wideband LPDA Antenna provides an ideal solution for 3G / 4G voice and data applications. With the rollout of new 3G and 4G frequencies such as 700  MHz 4GX and 2600 MHz 4G, traditional Yagi antennas just haven’t been able to keep up. LPDA antennas allow a single antenna to cover all frequencies with the high gain of a Yagi antenna that rural and remote areas demand. This one antenna can be used on any mobile phone network in Australia, in any area without worrying about compatibility.

 

 A Log Periodic Dipole Antenna, or LPDA for short, is a clever antenna design that provides exceptionally wideband performance by phasing a series of elements together, much like an ordinary yagi but with each successive element of a  smaller (or larger) length. The result of this clever engineering is an antenna that holds high gain, with good tuning, across the entire cellular frequency range.

 

SUPPORTED NETWORKS Telstra, Aldi Mobile, Boost Mobile, Woolworths Connect

IMPORTANT NOTE Cel-Fi GO will boost a single band at a time (either 3G 850 or  4G 700 or 4G 1800).